







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boxabl Bathroom Remodeling: The Fremont Owner’s Guide
Boxabl bathroom remodeling in Fremont typically runs $9,000 – $28,000 installed, depending on whether you’re refitting fixtures and finishes inside a Casita’s original wet core or rebuilding the shower, vanity, and floor assembly. Because the Casita arrives as a folded steel-and-panel system with factory-set plumbing chases, the work is closer to a precision retrofit than a stick-built bathroom remodel. We handle these as Fremont jobs with written scope, pulled permits, and inspections signed off.

Most owners find out something is wrong the same way: a soft spot near the shower pan, water wicking under the vanity edge, or a door that suddenly won’t latch because the floor has swollen. In Fremont’s older planned communities and the newer infill lots around Centerville and Irvington, we see this pattern most often in units that sat through a wet winter without a functioning exhaust fan.
Key Takeaways
- Installed Boxabl bathroom remodeling in Fremont: $9,000 – $28,000, with small wet-core refits from $5,000.
- The single biggest failure point is the factory shower pan and its drain connection, not the fixtures.
- OEM panels are sized to the Casita’s folded dimensions; aftermarket substitutes often need trimming and a re-inspection.
- Permits matter here. A wet-core alteration in Fremont needs a plumbing permit and a final inspection.
- We’re an independent contractor, not affiliated with Boxabl. We work on the unit, not for the manufacturer.
Which Boxabl Models This Applies To

Boxabl’s Casita is the model nearly every Fremont owner we meet actually has, and the bathroom core is built around a molded shower pan, a compact vanity, a factory toilet, and a mechanical exhaust tied into the unit’s electrical panel. The Casita has gone through design revisions since early production, and the wet-core dimensions have shifted slightly between runs. That matters: a shower pan pulled for a 2019-era Casita won’t drop into a later unit without checking the drain offset and the pan’s outer lip against the actual opening.
To identify what you have, look for the data plate inside the unit (usually near the electrical panel or the entry frame) and measure the shower opening yourself: length, width, and the distance from the drain center to the nearest wall. Write those three numbers down before you call anyone. That measurement set is what tells us whether an OEM replacement pan is the right match or whether a quality aftermarket pan trimmed to fit is the honest answer.
On the OEM-versus-aftermarket question: OEM gets you a drop-in fit and no surprises at inspection. Aftermarket gets you better materials, often at lower cost, but only if the installer measures carefully and the inspector signs off on the altered assembly. We quote both and put the difference in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Boxabl Bathroom Remodeling Is Failing
- Soft or spongy floor near the shower. The pan’s drain connection has likely failed and water is reaching the subfloor. In Fremont’s wet winters this shows up fast, sometimes within a single rainy season.
- Caulk that keeps re-cracking at the pan-to-wall joint. The pan is flexing underfoot, which means the support beneath it has lost integrity. Recaulking hides it for a few months and no longer.
- Musty smell that returns after cleaning. Moisture is trapped behind the wall panels or under the pan. A failed exhaust fan is usually the accomplice.
- Vanity doors that won’t close square, or a toilet that rocks. The floor assembly has swelled or the fasteners have pulled. This is structural, not cosmetic.
- Water staining on the ceiling below, if your Casita sits over a garage or crawlspace. The drain line is leaking at a joint. This one needs attention before the next rain, not after.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what Fremont homeowners actually pay for Boxabl bathroom remodeling, installed:
| Scope | Installed Range |
|---|---|
| Full bathroom remodel (wet core rebuild, fixtures, finishes) | $9,000 – $28,000 |
| Small bathroom remodel (compact Casita core) | $5,000 – $12,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Shower replacement (pan and surround) | $3,000 – $8,500 |
| Bathroom vanity installation | $800 – $3,000 |
What drives the range: whether the subfloor needs replacement, whether the plumbing chase has to be opened, and whether you’re choosing a stock vanity or a premium line like KraftMaid. We also install Cambria and Silestone tops when a homeowner wants stone in a small bath. Every line item, allowance, and price change is written down and signed before work begins. The finished job carries our 90-Day Done Right Promise: if something isn’t right, one call brings us back.

DIY or Call Us?
An owner can safely check a few things: run the exhaust fan and hold a tissue to the grille to confirm it pulls, press on the shower pan to feel for movement, and look under the vanity for staining. Those checks cost nothing and tell you a lot.
Where DIY goes wrong is the pan and drain. Replacing a shower pan means disconnecting the drain, lifting the old pan, checking and often rebuilding the subfloor, setting the new pan in a mortar bed, and reconnecting the drain with a proper seal. Get the mortar bed wrong and the pan flexes and cracks within a year. Get the drain seal wrong and you’re back to a soft floor. It’s also a plumbing alteration in Fremont, which means a permit. That’s the part most folks skip and regret.
If your checks point to a failing pan, call us at (833) 620-6162 for a free estimate. We’ll measure, tell you honestly whether OEM or aftermarket is the better call, and put the whole scope in writing.
FAQs

A well-maintained Casita bathroom core typically lasts 15 – 25 years before the pan or subfloor needs attention, but Fremont’s wet winters shorten that if the exhaust fan or caulk fails early. Homes near the bay fog belt see moisture problems sooner than inland units.
Sometimes, yes. A hairline crack in a solid pan can be patched with an epoxy kit and last a few more years. But if the pan is flexing or the subfloor is soft, patching is money spent on a problem that comes back. We’ll tell you which situation you’re in after we look.
A shower pan replacement in a Casita is typically a one-to-two-day job once the permit is in hand. A full wet-core remodel runs three to five days. We schedule around your water shutoff so you’re not without a bathroom longer than necessary.
We source OEM Boxabl components through the manufacturer’s parts channel and quality aftermarket equivalents from suppliers we’ve used for years. We don’t stock parts and we don’t carry them on a truck. We order what your measurement set calls for and confirm the fit before we schedule the install.
Barrett & Sons Construction Fremont is an independent contractor and is not affiliated with Boxabl. We’re owner-operated, every eligible job gets permits pulled and inspections signed, and a live person answers the phone 24/7. Ask about our published standing offers: $40 Off Any Repair Over $200, Free Second Opinion on Any Written Estimate, No Trip Charge Inside the County, and a permanent 10% Senior & Veteran discount. Call (833) 620-6162 to schedule your free estimate.
Written by the team at Barrett & Sons Construction Fremont, serving Fremont and nearby areas.












