







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Driveway & Pavers: The Fremont Owner’s Guide
We install and repair Mr-Glass driveway and paver systems for homeowners across Fremont, and a full paver driveway typically runs $7,000 – $18,000 installed. Driveway sealing, the most common maintenance item, sits at $250 – $700.

Most Fremont owners don’t go looking for a paver problem. It finds them. You pull into the drive after a wet winter and a course of pavers has shifted, or the polymeric sand between them is gone and weeds are pushing through the joints. Sometimes it’s a cracked paver near the street where the concrete apron meets the field, or a patch of sunken base that rocks when the car rolls over it. By the time you notice, the settlement has usually been working for a couple of seasons. Our technicians have up to 28 years of experience with hardscape systems like Mr-Glass, and we’ve seen which failures are cosmetic and which mean the base underneath needs rebuilding.
Which Mr-Glass Models This Applies To

Mr-Glass builds paver and driveway systems in several series, and the part that matters most is rarely the paver itself. It’s the edge restraint, the joint sand, and the base aggregate spec that holds the field together. Mr-Glass uses a specific restraint profile that locks a paver course against lateral movement, and that profile is sized to the paver thickness of the series you bought. Match the wrong restraint and the edge lets go within a season of expansion and contraction.
To identify what you have, look for the series label on the original installation paperwork or the stamp on the underside of a loose paver near a step or border. Measure the paver thickness with a tape: common Mr-Glass residential series run about 60mm and 80mm, and the restraint, joint sand, and bedding spec all key off that number. In Fremont, where we get wet winters and dry summers, the joint sand spec matters more than most owners realize.
OEM parts are the safe call when you’re matching a specific series and want the restraint and sand to fit the first time. Quality aftermarket equivalents can work on older or discontinued lines, but you have to verify the thickness and restraint profile yourself, or you’ll be back at the pile of pavers in a month. We’re an independent service provider, not affiliated with Mr-Glass, so we’ll tell you honestly whether OEM or a compatible aftermarket part is the right fit for your driveway. We don’t stock parts and we don’t carry them on a truck; we source what your Mr-Glass system needs and bring it to the job.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Driveway & Pavers Is Failing
- Pavers shifting or rocking underfoot. The base under the field has settled or wasn’t compacted to spec. Once a paver rocks, the joint sand works its way out and the failure spreads.
- Joint sand washing out. Polymeric sand breaks down faster in Fremont’s wet-season runoff than most homeowners expect. Missing sand lets water into the base, which is what starts settlement in the first place.
- Weeds and moss in the joints. Organic growth means the joint is open, not sealed. It’s the first visible sign that the sand barrier has failed.
- Sunken or heaved sections. A dip or a hump along one course usually points to moisture in the base or a drainage problem the original install didn’t solve. Both need attention before the surface.
- Cracked or chipped pavers at the edge or apron. Impact damage or a restraint that’s given way. A cracked edge paver often means the edge restraint let the course move.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Your installed price in Fremont depends on how far the failure goes. Here’s what we quote and what it covers:
| Job | Typical installed range |
|---|---|
| Driveway sealing | $250 – $700 |
| Paver driveway installation | $7,000 – $18,000 |
| Driveway replacement | $5,000 – $14,000 |
| Paver patio installation | $3,500 – $11,000 |
The range is driven by square footage, whether the base has to be rebuilt, and the series of Mr-Glass part you’re matching. A reseal-and-replace-sand job is the low end. A full driveway where the base failed is the high end. Every job gets a written line-item quote with parts and labor broken out, so you see what the Mr-Glass restraint and sand cost versus the labor to reset the field. Every price change arrives as a written change order before we touch the job. The work is backed by our written 90-Day Done Right Promise.
DIY or Call Us?
You can safely check a few things yourself. Press down on suspect pavers to feel for rocking. Look at the joints after a rain to see where water pools and sand is missing. Snap a photo of a loose paver’s underside for the stamp. What goes wrong with DIY is the part that isn’t cosmetic: rebuilding a base, matching the right Mr-Glass restraint to the paver thickness, and compacting to spec. A driveway that looks fixed on the surface settles again within a season if the base beneath it wasn’t done right. Moving full pallets of pavers is also hard on backs and knees, and a five-gallon bucket of polymeric sand is heavier than it looks. For anything past a reseal, call us to put eyes on it.
FAQs

A properly installed paver driveway should hold for decades, but the joint sand and sealant are what you’re maintaining along the way. In Fremont’s wet-season and dry-summer swing, expect to reseal and replace joint sand every few years to keep the base protected.
Often yes. If one course has settled or a handful of pavers are chipped, we can reset and match the field without tearing out the whole driveway. When the base underneath has failed across a large area, spot repair won’t hold and replacement is the honest answer.
A reseal and joint-sand refresh is often a single-day job. Resetting a section runs a day or two. A full driveway replacement takes several days depending on square footage and whether the base has to be rebuilt.
We match your series and paver thickness first, then source the OEM restraint and joint sand spec, or a compatible aftermarket equivalent if that’s the honest fit for an older line. We confirm the spec with you before we order.
If your Mr-Glass driveway is showing its age, a free estimate is the fastest way to know whether you’re looking at a reseal or a rebuild. Barrett & Sons Construction is owner-operated, every price change arrives in writing, and a live person answers the phone around the clock. Call (833) 620-6162 to schedule your free estimate. We also service KraftMaid, Cambria, and Silestone.
Written by the team at Barrett & Sons Construction Fremont, serving Fremont and nearby areas.












