







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Fence Installation: The Fremont Owner’s Guide
Fence installation that uses Belgard hardscape components in Fremont typically runs $3,500 – $9,000 for a full fence line, and every job starts with a free on-site estimate and a written scope. Most Fremont owners find out something is wrong the same way: a post starts leaning after a wet winter, a panel sags at the gate, or the footer lifts and the cap stones wobble. Belgard doesn’t make a standalone fence post or panel line the way it makes pavers and wall block, so what actually gets installed is a Belgard-matched masonry pier or pillar system built with Belair, Tremron-style or Allen-block wall units, with the fence panels anchored between them. That distinction matters, because it decides which part you’re replacing and how it’s priced.

We’re Barrett & Sons Construction Fremont, an independent builder and not affiliated with Belgard. We install and repair fence systems that use Belgard wall block and caps, and we pull the permit and put the price in writing before work starts.
Key Takeaways
- Belgard fence builds in Fremont: $3,500 – $9,000 installed, depending on length, block series and footer depth.
- Belgard supplies the block and caps, not a single “fence kit” – the pier and panel detail is a builder decision.
- Fremont’s clay soils and winter rain are what fail these fences first, not the block itself.
- We issue a written change order before any scope or price change, every time.
- Every eligible job gets pulled permits and a signed inspection.
Which Belgard Models and Block Series This Applies To

There’s a compatibility gotcha worth knowing before you go hunting for a matching unit. Belgard’s wall lines – Belair, Brighton, Aberdeen, Weston Stone and the Belair Wall system among them – vary in face dimensions and cap depth between series, and a single course height from one series may not align with another. If your fence pier is built in Belair and you replace a damaged unit with a Brighton block, the course lines won’t line up and the cap won’t seat flat. Match the series, not just the color.
To identify what you have, measure a face unit (height, width, depth in inches) and measure the cap length and thickness. Look for a stamp or casting mark on the back of a loose cap if you can get to one; many Belgard caps carry a mold mark. Photograph the course pattern before you remove anything. On an exact-match situation, an OEM Belgard unit is the safe call, and a quality aftermarket block is fine for a decorative pier that’s getting painted – but never mix them on a structural corner.
This same brand-matching thinking shows up in our other trade work too. A kitchen with KraftMaid cabinetry, a Cambria or Silestone top and the right hardware all has to line up the same way. Get the series right and the fence lasts; get it wrong and every unit downstream is off.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Belgard Fence Installation Is Failing
Fremont sits on heavy clay ground, and that’s the biggest single cause of failure we see. Clay swells in the wet season and shrinks hard in summer, so a pier footer that was set with too little depth or no gravel base will rock within a couple of seasons. Here’s what to look for:
- Leaning piers after rain. The footer is moving, not the block. Water is getting under the base and lifting one side. That’s a footer and drainage fix, not a block swap.
- Sagging fence panels at the gate. The gate post is undersized for the span or the hinge bolts have pulled. On a Belgard pier build, this usually means a pier wasn’t tied to the panel rail correctly.
- Caps that rock or lift. Adhesive failed or the unit is sitting on a low spot. A cap that shifts lets water in and freezes the problem into the block below.
- Efflorescence – white chalky staining. Normal in concrete block, but if it keeps coming back after Fremont’s rainy season it means water is wicking through a joint that wasn’t sealed. It’s cosmetic until the joint opens.
- Spalling faces – flaking or pitting on the block face. Usually a sign of a bad batch, freeze-thaw, or physical damage from a string trimmer or vehicle. If it’s spreading, replace the unit before the edge breaks down further.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost and What’s Included for Fremont
Typical installed price for a Belgard-compatible fence build in Fremont is $3,500 – $9,000. Repairing a single leaning pier or replacing damaged caps usually lands well under that – call for a free estimate and we’ll give you a line-item number.

| Scope | Fremont range |
|---|---|
| Single pier rebuild (footer, block, cap) | $400 – $1,200 |
| Cap replacement, matching series | $150 – $500 |
| Short run with Belgard piers, up to ~40 ft | $3,500 – $6,000 |
| Full run, ~40 – 80 ft with piers | $6,000 – $9,000 |
What moves the range: total length, block series and unit cost, footer depth driven by soil conditions, and whether a permit or inspection is required. We itemize parts and labor so you can see exactly what a Belgard wall unit costs versus the footer and labor. Every job that needs a permit gets one pulled, and every completed job is covered by our 90-Day Done Right Promise in writing.
DIY or Call Us?
Someone with a strong back and a wheelbarrow can safely inspect their own fence. Check for leaning piers, loose caps, and joint gaps, and take photos. Re-setting a cap with construction adhesive is within reach for a careful homeowner.
What goes wrong: rebuilding a pier footer. That’s the part that keeps the whole run standing, and getting it wrong means you’re back out there next spring. Set a footer too shallow on Fremont clay and the pier will rock no matter how good the block work is. A pier carrying a fence panel also has real load on it, and an improperly anchored unit can pull loose and fall on someone. Our crew members have up to 28 years of experience with this exact soil and these exact block lines. If you’re not sure the pier is sitting on solid ground, don’t gamble on it. Call (833) 620-6162 and we’ll take a look.
FAQs

Twenty-five to forty years is realistic when the footer and drainage are done right. The block itself holds up well; the footer, base prep and joint sealing are what determine lifespan, especially in Fremont’s clay soil and wet winters. Call (833) 620-6162 for a free estimate on your fence.
Often, yes. A single leaning pier or a set of cracked caps can usually be rebuilt or swapped without touching the rest of the run, as long as the block series is still available. If the footer has shifted across multiple piers, the fix is structural and needs a full assessment. Call (833) 620-6162 and we’ll tell you straight which it is – the estimate is free.
A single cap swap is an afternoon. A pier rebuild runs one to two days depending on footer cure time. A full Belgard pier fence run is typically three to five working days for a 40-80 ft span. Call (833) 620-6162 to get a firm schedule with your free estimate.
We source matching Belgard wall block and caps from authorized suppliers to fit your existing series, and if a series is discontinued we’ll tell you before you buy anything. Yes – matching the series matters, because face heights and cap depth differ between lines and a mismatched unit won’t sit flush. Call (833) 620-6162 for a free written estimate and we’ll confirm your series before work starts.
If your fence is leaning, the caps are rocking, or you just want an honest number before you decide anything, call Barrett & Sons Construction Fremont at (833) 620-6162. A live person answers the phone around the clock. We’ll come out, measure, and hand you a free written estimate with the scope, the parts and the price all on paper. No trip charge inside the county, a free second opinion on any written estimate you’ve already got, and a permanent 10% senior and veteran discount.
Written by the team at Barrett & Sons Construction Fremont, serving Fremont and nearby areas.












