







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Bathroom Remodeling: The Fremont Owner’s Guide
Bathroom remodeling in Fremont using IKO system components typically runs $9,000 to $28,000 installed, with small baths at $5,000 to $12,000 and walk-in showers at $4,500 to $12,000. We’re an independent contractor, not affiliated with IKO, and we install IKO waterproofing and shower system components alongside KraftMaid, Cambria, and Silestone finishes. Owners usually find out something is wrong the slow way: a hairline crack in the shower pan membrane, a weepy grout line that never dries, or a soft spot under the tile that squishes when they step out of the tub. By then the damage has usually been working behind the wall for a season or two.

Which IKO Models This Applies To

IKO’s bathroom line covers shower waterproofing membranes, drain assemblies, and tile backer systems, and the pieces aren’t interchangeable across product generations. The fastest way to identify what you have is to look at the drain flange on the shower floor: if you can see the membrane clamped under the flange with a visible bolt ring, it’s a clamping-ring assembly, and the replacement membrane flange has to match the bolt pattern and the drain body diameter exactly. The other common setup is a bonded membrane that glues directly to a pre-sloped drain, and mixing the two is the number one ordering mistake we see in Fremont.
On the OEM-versus-aftermarket question: IKO-branded membranes and drain parts are what we specify because the warranty path is clean and the dimensions match what’s already in your wall. Quality aftermarket equivalents exist and can save you money on the membrane itself, but the drain assembly is where we stop cutting corners, because a mismatched flange is a leak waiting for a season of rain to show it. Pull the label off any leftover material in the garage, or photograph the drain from directly above with a tape measure across it, and we can match the part before we touch a tile.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Bathroom Remodeling Is Failing
- Grout that stays dark after a shower. When the membrane beneath has lost its seal, moisture wicks up through the thinset and never fully dries. A grout line that’s still wet two hours after the last shower is telling you water is trapped under the tile.
- A soft or flexing spot on the shower floor. This usually means the pre-sloped mortar bed has broken down or the drain connection has been weeping for months. Step on it in socks and you’ll feel the give before you see any stain.
- Water staining on the ceiling below. In Fremont’s older single-story homes, a shower pan failure often shows up as a brown ring on the garage ceiling or the room below. That’s a membrane failure, not a caulk problem.
- Loose tile around the drain or curb. Adhesion loss at the drain flange and curb is the first place a failing waterproofing system lets go. If tile taps hollow there, the bond has already broken.
- A persistent musty smell that doesn’t clear with cleaning. That’s mold growing behind the tile in the wall cavity. IKO system failures behind the wall are the common culprit, and it doesn’t go away with a stronger bathroom fan.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
A full bathroom remodel in Fremont lands between $9,000 and $28,000 depending on square footage, fixture count, and whether we’re reconfiguring the layout or working within the existing footprint. Small bathrooms run $5,000 to $12,000. A walk-in shower installation is $4,500 to $12,000, a tub-to-shower conversion is $3,500 to $10,000, and a straight shower replacement is $3,000 to $8,500. A vanity swap on its own is $800 to $3,000.
What drives the range: tile selection, whether the drain needs to be relocated, whether we’re opening a wall to fix framing, and the finish level on fixtures and glass. You get a written line-item quote before we start, and if anything changes scope once we’re in the wall, a written change order gets signed before any work continues. Every eligible job gets permits pulled and inspections signed. Every completed job carries the written 90-Day Done Right Promise.

DIY or Call Us?
There’s a short list you can safely check yourself: photograph the drain, measure the flange, note whether the grout stays wet, and confirm whether the ceiling below shows staining. That information is genuinely useful and costs you nothing.
Where DIY goes wrong is the tear-out and re-waterproofing. Removing tile around a failed membrane almost always reveals rot in the subfloor or framing that wasn’t visible, and once that’s open, the rebuild has to be done to code or the inspector will fail it. We’ve seen plenty of Fremont bathrooms where a homeowner tried a surface patch and it failed again within a year, costing more than doing it right the first time. Our crew members have up to 28 years of experience, every permit gets pulled, and every price change is in writing before work moves. Call (833) 620-6162 and we’ll walk you through what we’re seeing.
FAQs

How long does an IKO bathroom system last in Fremont? A properly installed IKO waterproofing system typically lasts 15 to 25 years. The variable in Fremont is our mild, damp winters, which keep a shower pan wet longer than in a dry climate and punish any flaw in the drain connection. Call (833) 620-6162 for a free estimate on your specific bathroom.
Can the membrane be repaired instead of replaced? Sometimes. A localized failure at the drain flange can sometimes be repaired without a full tear-out, but a membrane that’s failed across the pan usually can’t. We’ll tell you honestly which situation you’re in after we look at it. Call (833) 620-6162 to schedule the inspection.
How long does the swap take? A straight shower replacement typically takes 4 to 7 working days once materials are on site. A full bathroom remodel runs 2 to 4 weeks depending on scope. Call (833) 620-6162 for a timeline on your project.
How do you source the IKO part? We match the drain assembly and membrane to the exact model and generation already in your bathroom, using IKO-branded components so the warranty path stays clean. If you have the old material or a photograph of the drain, bring it to the estimate. Call (833) 620-6162 to get started.
Written by the team at Barrett & Sons Construction Fremont, serving Fremont and nearby areas.












