







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Driveway & Pavers: The Fremont Owner’s Guide
We install IKO-compatible driveway and paver systems across Fremont, and the typical installed price runs $7,000 – $18,000 for a paver driveway, $3,500 – $11,000 for a paver patio, and $250 – $700 for sealing. Diagnosing a failed section, matching the replacement, and setting it in place is not same-day work; the honest timeline runs a few days to a week depending on square footage and access. Barrett & Sons Construction is an independent contractor and is not affiliated with IKO.

Owners usually find out something is wrong the same way. They pull into the driveway after a wet winter and see a hollow sound under the tires where a paver rocks. Or a hairline crack opens along a joint and water starts pooling against the garage sill. In Fremont, the discovery often comes in March, after weeks of rain have worked into the base and the first warm weekend shows the damage. By the time you notice the rocking, the failure is usually underneath, not on top.
Which IKO Models This Applies To

IKO is best known for roofing, but the hardscape side sells concrete and clay pavers in specific series. The exact product line matters because thickness, edge style, and the interlocking profile have to match for a repair to sit flush. Pull the label off a leftover piece from the original install if you have one. If not, measure one paver in three places: length, width, and thickness. IKO concrete pavers commonly run in the 2 3/8-inch thickness range for residential driveways, but you need to confirm against your actual pieces rather than trusting a spec sheet.
Once you have the measurements, match them to the series. A 60mm paver won’t sit level next to a 50mm paver, and the joint lines will telegraph it the first time the sun hits. On the OEM-versus-aftermarket question: an IKO replacement paver of the same series is the cleanest fit because the color lot and profile match. A quality aftermarket equivalent can work if the thickness and interlock match and you accept a slight color shift that ages in over a season or two. For a small repair, matching the profile matters more than the label. For a full driveway, the series choice is worth getting right the first time.
Identifying your system correctly is the whole job. Get the label, get the measurements, get the series, and the rest is straightforward.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Driveway & Pavers Is Failing
Here’s what a failing driveway or paver field looks like, and what’s usually behind it:
- Rocking or hollow-sounding pavers. A paver that shifts underfoot or sounds hollow means the bedding sand and base have separated. This usually starts at the edge or a low corner where water collects.
- Sand washing out of the joints. If the joints are empty and the pavers look exposed, water is moving through faster than the base can drain. In Fremont’s clay-heavy soils, that water has nowhere to go and backs up under the field.
- Heaving or uneven sections. A hump or dip forming over one area points to a base problem, often compacted too little or laid over a buried root. It gets worse with each wet season.
- Weed and moss growth in the joints. Persistent weeds signal empty joints holding organic debris. On a shady north-facing slab, that’s a reliable sign the joint sand has gone.
- Cracks in individual pavers. A cracked paver usually means point loading from a base that’s settled. Replacing the paver without fixing the base underneath just moves the problem to the next one.
The pattern matters more than any one symptom. One rocking paver near the garage is a small fix. A field of them across the driveway is telling you the base itself needs attention.
Replacement Cost & What’s Included

For Fremont homeowners, the installed pricing breaks down like this. These ranges are what the market runs in this area, and we quote against them with a written line-item estimate before anything starts:
| Work | Installed Range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Concrete driveway (alternative) | $4,500 – $12,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
What drives the range: square footage, base condition (a failing base means excavating and recompacting, which is the biggest cost swing), paver series and color lot, and access for equipment. A driveway that’s just the pavers is one number. A driveway with a soft base under half of it is another.
Every scope, allowance, and price change arrives as a written change order before work begins. No surprise invoice at the end. Permits get pulled where eligible, and the work is covered by our written 90-Day Done Right Promise. If something isn’t right, one call brings us back.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Here’s the honest split. What you can check yourself: walk the driveway and mark each rocking paver with chalk, measure the thickness and joint width, and check whether water is draining away from the house or pooling against it. Take a photo of the label and a couple of the worst spots. That’s useful information and worth doing before you call anyone.
Where DIY goes wrong on pavers is the base. Pulling up a paver and setting a new one in sand looks easy, and that’s the trap. The paver fails again next wet season because the compacted base under it was never fixed. On a driveway, a base that’s been undermined and not recompacted will keep shifting, and you’ll be chasing the same paver every year. This is heavy, leveling work, not a weekend project. The pavers themselves aren’t dangerous, but lifting and relaying a compacted base calls for equipment most homeowners don’t have.
If the driveway is failing across a section, that’s the moment to get a written estimate. Call (833) 620-6162 and we’ll walk it with you.
FAQs

How long do IKO pavers last in Fremont? An IKO concrete paver properly set on a compacted base lasts 25 to 30 years or more. The failure usually isn’t the paver, it’s the base and joints. In our clay soils, joint sand maintenance and sealing every few years are what push a driveway into the long end of that range.
Can a failing paver be repaired instead of replaced? Often, yes, if it’s isolated. A single rocking or cracked paver can be lifted, the base under it recompacted, and the paver reset. If a whole section is shifting, a repair only buys time until the base is addressed. We’ll tell you which one you’re looking at after we look.
How long does the swap take? A single-paver repair is an afternoon. A section repair runs one to two days. A full paver driveway install typically takes three to five days depending on square footage and base condition. We give you the timeline in the written estimate before work starts.
How do you source the IKO pavers? We order the replacement pavers by series, thickness, and color lot so the new pieces sit flush and match the field. We don’t keep stock on hand and nothing gets carried on a truck. Sourcing is part of the written scope, with the cost on paper before we order.
Call (833) 620-6162 for a free estimate on your Fremont driveway or paver repair.
Contact Us for a Free Estimate
If your IKO driveway or paver field is rocking, cracking, or washing out, call (833) 620-6162 to schedule a free estimate. We’ll measure, match the series, and give you a written line-item quote. We also service KraftMaid, Cambria, and Silestone when other parts of your home need work. Proudly serving local communities for over 29 years, founded in 1998 and owner-operated from day one. A live person answers the phone 24/7.
Written by the team at Barrett & Sons Construction Fremont, serving Fremont and nearby areas.












